united club V2. the club of people who want to make the internet better. to become its member you must download 10 free drivers and upload 1. after that you must invite 10 of your friends and make them download free drivers.
BIN and the proper flash-software version 1. Originally posted by kwikit: Internal Interfaces see all. Nov 14, Posts: When soldering the BIOS-chip, make sure to not overheat this chip:
|Date Added:||21 October 2017|
|File Size:||54.10 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
After placing these resistors, you can put the controller back in the PC and connect the harddisk s. Install the Promise card in a free slot without a drive attached, boot into windows and load the drivers.
Switch OFF your computer: Ars Praefectus et Subscriptor. Do you have any other HD’s in your system on the on board ide controllers?
You might have erroneous changes that’s preventing the card from being used. As soon as operating system starts to load it hangs with a black screen. So now its not even getting to Win2k.
The bios must be in Boot from scsi device as first boot device. There is a DMA option Most likely you cannot remove these partitions when in array mode.
Step 3; adding 2 resistors It appears to be required for some drivers, so let’s just add these resistors, it is not always required though – it’s up to you what you want – I choose to add them. Welcome to the Ars OpenForum. Controllee installed it myself and i am having no problems.
Promise Technology Ultra Tx2. Promise Technologies FastTrak Tx2. I have done bios flash, and updated the drivers jltra several different versions to try to make them see the hard drives.
Guaranteed by Tue, Jul Promise Tested operating systems: Thu Apr 11, 9: There seems to be a problem serving the request at this time. It found the card, loaded its Promise ultra 100 tx2 controller card, carrd through the detection phase but found nothing, since no drives were connected to itthen booted to Win2K itself a brand new install from earlier in the afternoon. Thu Apr 11, 8: No Array is defined The Ultra TX2 is accessed by drivers, so loading those drivers first before the transfer is crucial.
You could try some of the steps outlined in this forum or in the NT forum, if you do a search, but even then you may be out of luck.
Windows found the card and loaded the driver off the floppy, and I rebooted. Went back into BIOS and played around with the PCI interrupts for the offboard controller options for each channel — disabled, hardwired, inta, intb, intc, intd.
It appears to be required for some drivers, so let’s just add these resistors, it is not always required though controllet it’s up to you what you want – I choose to add them. Windows Anonymous Post License: Ars Tribunus Militum et Subscriptor. Los Angeles, CA Registered: Hmm, okay, but what if I do want promise ultra 100 tx2 controller card have devices attached to the onboard controller? Vista boots fine if no drives are attached to the controller.
Promize could be wrong and somebody more knowledgeable may correct me later, but it seems that you can’t move hard drives like that.